CLUB (.400) - Motor Requirements & Specifications
CLUB (.400)



Home Introduction General Regulations Race Procedures Motor Requirements & Specs. Official Rules News

Upcoming Events Race Results Media Contact Us Slot Links Drag Board

 

 

MOTOR REQUIREMENTS
&
SPECIFICATIONS

 

 

SECTION 3

All classes limited to one (1) motor in car/truck.

*MOTOR: PROSLOT - VR-eXtreme NEO: PART NUMBER PS-4021, VR-20 NEO: PART NUMBER PS-4020, VR-12 NEO: PART NUMBER PS-4019

*CAN: Any cutting, welding or machine work prohibited.

*END BELL: Hardware must be VR-Series. Clearance of hardware to commutator if close, Copper hardware permitted. Any cutting or machine work is prohibited.

*MAGNETS: May be zapped, but must reside in original position in can (0.530" minimum air-gap (+/- 0.002"). Gluing and shimming of magnets for air-gap adjustment prohibited.

*BRUSHES/SPRINGS: Any type of brushes may be used. Any springs may be used. Shunt wires permitted.

*BEARINGS/BUSHINGS: Ball bearings allowed in classes that permit them. Bearings, and bushings may be epoxied or soldered in place.

*ARMATURES: Truing of commutator and armature re-balanced permitted. Must meet the following specifications:
*VR-eXtreme: Part Number PS-4023 Machine wound, 0.500 diameter.
*VR-Group20: Part Number PS-4022 Machine wound, 0.500 diameter
*VR-Group12: Part Number PS-4026 Machine wound, 0.500 diameter

Click Here: For General Regulations.

If there is any area of these rules which needs clarification, please contact CLUB (.400) Technical Director by e-mail at club400@hotmail.com.

CLUB (.400): TAKING HEADS-UP SLOT CAR DRAG RACING TO THE NEXT LEVEL!!


Copyright 2001 - 2018 CLUB (.400) All Rights Reserved.
Designed & Maintained by: